top of page

GETTING STARTED WITH THE
DISPENSE-O-NET SYSTEM!

ASSEMBLY INSTRUCTIONS

Please follow the installation instructions in the CORRECT ORDER as some actions are not easily reversible. 

1 Assemble Dispenser: 

1.1

Remove the printed protective film from the Power Strip inside the dispenser. 

Instructions to assemble the dispenser. attach comb teeth face up to inside floor of dispenser and press firmly.

1.2

With the dispenser on a firm, flat surface, slide the tear comb through the opening with the teeth sticking through the front gap down to the exposed Power Strip. 

Be sure the teeth of the comb are pointing upward. 

Instructions to assemble the dispenser. attach comb teeth face up to inside floor of dispenser and press firmly.

1.3

Use firm, but not excessive, pressure to secure the comb to the adhesive. 

Instructions to assemble the dispenser. attach comb teeth face up to inside floor of dispenser and press firmly.

2 Affix to wall:

2.1

Choose an area near the entryway to the workspace. The dispenser should be approximately 4½ - 5 feet from the ground with at least 12 inches of clearance below the dispenser. Use the enclosed screws (and anchors, if necessary) or Power Strips to affix the dispenser to the wall. 

attach to wall approximately 5 feet from the ground.

3 Load Cartridge: 

​3.1

Remove the hygienic protection film from the box and slide the cartridge into the dispenser. 

Load cartrige, remove film, and place first hairnet in comb.
Dispense o net hairnet image

Patent: #8,881,747 and #9,820,546 
 
Disclaimer: No warranties are extended and no liability is assumed. The above information is provided solely as a general guideline for product use and care.  

3.2

Pull out the first hairnet just a bit and secure it in the teeth of the comb. 

Load cartrige, remove film, and place first hairnet in comb.
bottom of page